Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of License Lamp

Courtesy of GENERAL MOTORS CORP.

Install the bulb to the socket.
Install the socket to the license plate lamp (2) by turning the socket clockwise.
Install the license plate lamp (2) to the rear bumper fascia.

CAUTION: Refer to Fastener Caution .

Install the screws (1) to the license plate lamp. Tighten the license plate lamp screws to 2 N.m (18 lb in).
Install the license plate to the rear bumper fascia.