Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

CAUTION: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

Fig 1: View Of Hood Strut Rod

Courtesy of GENERAL MOTORS CORP.

Raise and support the hood.
Release the hood assist rod upper and lower retainer using a small flat-bladed tool.
Remove the hood assist rod (1) from the vehicle.