LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction - Driver >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the driver seat belt buckle.
  2. Test for infinite resistance between the signal terminal B and the low reference terminal A with the seat belt buckle unbuckled.
    • If not the specified value, replace the driver seat belt buckle.
  3. Test for less than 2.0 ohms between the signal terminal B and the low reference terminal A with the seat belt buckle buckled.
    • If greater than the specified range, replace the driver seat belt buckle.
scientia non olet · About LEMON Manuals