Installation Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Position the lock striker to the alignment marks.
- Install and hand tighten the striker and bolts (1).
- Slowly close the compartment lid. Inspect the striker alignment.
- Tighten the lock striker bolts (1). Tighten the rear compartment lid lock striker bolts to 10 N.m (89 lb in).
CAUTION:
Refer to Fastener Caution
.