Turn Signal Switch Bracket Replacement

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Turn Signal Switch & Bracket

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement
1	Turn Signal Switch Bracket Procedure Release the plastic retaining tabs and remove the turn signal switch bracket from the steering column. Disconnect any electrical connectors as needed, release the plastic retaining tabs, and remove the turn signal multifunction switch. Disconnect any electrical connectors as needed, release the plastic retaining tabs, and remove the windshield wiper and washer switch.

Callout

Component Name

Preliminary Procedure:
Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement

Turn Signal Switch Bracket

Procedure

Release the plastic retaining tabs and remove the turn signal switch bracket from the steering column.
Disconnect any electrical connectors as needed, release the plastic retaining tabs, and remove the turn signal multifunction switch.
Disconnect any electrical connectors as needed, release the plastic retaining tabs, and remove the windshield wiper and washer switch.