LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Aligning Manufacturer Match Marks On Lower Shaft
    GM2184305Courtesy of GENERAL MOTORS CORP.
  1. If you are installing a NEW steering column, align the manufacturer match marks (1) on the lower shaft.
  2. If you are installing a NEW steering column, copy the scribe marks from the old column to the new column.
  3. Install the power steering assist motor. Refer to Power Steering Assist Motor Replacement .
  4. Position the steering column in the vehicle.
    5. Fig 2: View Of Steering Column
    GM854962Courtesy of GENERAL MOTORS CORP.
  5. Start the steering column lower and upper support bracket bolts.
    6. CAUTION: Refer to Fastener Caution .
  6. Tighten the steering column lower support bracket bolt to 25 N.m (18 lb ft).
  7. Tighten the right side steering column upper support bracket bolt to 25 N.m (18 lb ft).
  8. Tighten the left side steering column upper support bracket bolt to 25 N.m (18 lb ft).
  9. Connect the intermediate steering shaft to the steering column shaft. Refer to Intermediate Steering Shaft Replacement .
  10. Connect any electrical connectors as necessary.
  11. Install the steering column opening filler. Refer to Steering Column Opening Filler Replacement .
  12. If equipped with RPO JL4, center the steering angle sensor. Refer to Steering Angle Sensor Centering .
scientia non olet · About LEMON Manuals