LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Blower Motor & Motor Cup
    GM1543473Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor (1) into the motor cup (2) that was cut out of the lower case.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the blower motor nuts (3).

    Tighten:  Tighten the nuts to 2.4 N.m (21 lb in).

  3. Attach the service ring (4) to the motor cup (2) with the screws (5) included in the kit.

    Tighten:  Tighten the screws to 1.8 N.m (15 lb in).

  4. Install the blower motor and service ring into the HVAC module using the screws (5) included in the kit. Make certain the blower motor electrical connector is pointing rearward in the vehicle.

    Tighten:  Tighten the screws to 1.8 N.m (15 lb in).

    5. Fig 2: Identifying Lower Motor Cover
    GM1543404Courtesy of GENERAL MOTORS CORP.
  5. Install the lower blower motor cover.
  6. Install the lower blower motor cover retaining screws.

    Tighten:  Tighten the screws to 1.8 N.m (15 lb in).

    7. Fig 3: View Of Blower Motor Electrical Connector
    GM1543403Courtesy of GENERAL MOTORS CORP.
  7. Connect the blower motor electrical connector.
scientia non olet · About LEMON Manuals