LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Evaporator Hose Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Evaporator Tube & Compressor Suction Hose At TXV
    GM872539Courtesy of GENERAL MOTORS CORP.
  1. Install new sealing washers on the condenser tube and evaporator hose fittings. Refer to Air Conditioning System Seal Replacement .
  2. Install the condenser tube and evaporator hose to the TXV.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the TXV nut.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

    4. Fig 2: Locating Compressor Hose Nut
    GM2044592Courtesy of GENERAL MOTORS CORP.
  4. Install new seal washer to the compressor hose. Refer to Air Conditioning System Seal Replacement .
  5. Install the compressor hose and nut (1) to the evaporator hose.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  6. Install the charge air cooler inlet pipe. Refer to Charge Air Cooler Inlet Pipe Replacement
  7. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
  8. Leak test the fittings using the J 39400-A  . See Special Tools .
scientia non olet · About LEMON Manuals