LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Compressor Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Remove the charge air cooler outlet pipe. Refer to Charge Air Cooler Outlet Pipe Replacement
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    4. Fig 1: View Of Pressure Transducer Electrical Connector
    GM872571Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the pressure transducer.
    5. Fig 2: View Of Compressor & Condenser Hose Assembly
    GM865182Courtesy of GENERAL MOTORS CORP.
  5. Remove the compressor and condenser hose assembly bolt from the compressor.
  6. Remove the compressor and condenser hose assembly from the compressor.
  7. Remove and discard the sealing washers.
    8. Fig 3: View Of Compressor Hose At Condenser
    GM872545Courtesy of GENERAL MOTORS CORP.
  8. Remove the compressor hose from the condenser.
  9. Remove and discard the seal washer.
  10. Lower the vehicle.
    11. Fig 4: Identifying Compressor Hose Nut & Bracket Bolt
    GM2044556Courtesy of GENERAL MOTORS CORP.
  11. Remove the compressor hose nut (1) from the evaporator hose.
  12. Remove the wiring harness from the compressor hose bracket.
  13. Remove the bolt (2) from the compressor hose bracket.
  14. Remove and discard the seal washer.
scientia non olet · About LEMON Manuals