LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning (A/C) Evaporator and Blower Module Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the HVAC module from the vehicle. Refer to Air Conditioning and Heater Module Assembly Removal and Installation .
    2. Fig 1: View Of Heater Core Cover
    GM1548653Courtesy of GENERAL MOTORS CORP.
  2. Remove the heat stakes from the heater core cover using a small chisel and remove the cover.
    3. Fig 2: View Of Heater Core
    GM872606Courtesy of GENERAL MOTORS CORP.
  3. Remove the heater core.
    4. Fig 3: View Of HVAC Case
    GM1548656Courtesy of GENERAL MOTORS CORP.
  4. Remove the heat stakes that secure the lower HVAC case to the HVAC module using a small chisel.
    5. Fig 4: View Of Lower HVAC Case
    GM877662Courtesy of GENERAL MOTORS CORP.
  5. Unsnap and open the passenger compartment filter door.
  6. Remove the lower HVAC case.
    7. Fig 5: View Of Evaporator Core
    GM877663Courtesy of GENERAL MOTORS CORP.
  7. Remove the evaporator core.
scientia non olet · About LEMON Manuals