Circuit/System Description

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

The passenger presence system (PPS) is used to monitor the weight of an occupant in the front passenger seat. The PPS is calibrated at the seat assembly plant and cannot be recalibrated at a service center and must be replaced. The PPS continuously monitors itself and if the system becomes out of calibration, DTC 063 will be set. When the PPS detects this DTC within the PPS, it will notify the customer of the enable/disable status by illuminating the OFF indicator on the PASSENGER AIR BAG ON/OFF indicators. Then the PPS will communicate to the sensing and diagnostic module (SDM) through serial data communication circuit that a PPS fault is present. The SDM will then set DTC B0081 indicating a problem within the PPS and will suppress the deployment of the instrument panel (I/P) module and then illuminate the AIR BAG warning indicator.