LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Instrument Panel System Displays & Gauges) >> Diagnostic Information and Procedures >> Fuel Gauge Inaccurate or Inoperative >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, remove the fuel level sender.
  2. While sweeping the fuel level sensor through its full range of motion, test for a minimum value of less than 41 ohms and a maximum value greater than 119 ohms between signal terminal C and the low reference terminal D.
    • If not within the specified range, replace the fuel level sensor.
scientia non olet · About LEMON Manuals