LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Instrument Panel System Displays & Gauges) >> Diagnostic Information and Procedures >> DTC B0158 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the ambient air temperature sensor.
  2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal B and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  3. Ignition ON, verify the scan tool Ambient Air Temp. Sensor parameter is greater than 4.7 volts.
    • If less than the specified range, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the BCM.
  4. Install a 3-amp fused jumper wire between the signal circuit terminal A and the low reference circuit terminal B. Verify the scan tool Ambient Air Temp. Sensor parameter is less than 0.4 volt.
    • If greater than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the ambient air temperature sensor.
scientia non olet · About LEMON Manuals