LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Back Cushion Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Latch Assembly
    GM876786Courtesy of GENERAL MOTORS CORP.
  1. Install the latch assembly.
  2. Feed the cable and the release handle through the sheet metal to the rear compartment.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the rear seat back latch bolts and tighten to 12 N.m (106 lb in).
    4. Fig 2: View Of Latch Assembly Grommet
    GM888319Courtesy of GENERAL MOTORS CORP.
  4. Install the grommet.
    5. Fig 3: View Of Latch Release Cable
    GM876787Courtesy of GENERAL MOTORS CORP.
  5. Install the rosebud fastener to the latch assembly cable.
  6. Install the release handle and engage the handle in the clip.
    7. Fig 4: Lower Lock Pillar Molding
    GM1734064Courtesy of GENERAL MOTORS CORP.
  7. Install the lower lock pillar garnish molding fastener (1).
scientia non olet · About LEMON Manuals