Windshield Garnish Molding Replacement
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Windshield Garnish Molding Bolt Hole Finish Plug |
| 2 | Windshield Garnish Molding Screw
CAUTION:
Refer to Fastener Caution
.
Tighten: 2 N.m (18 lb in) |
| 3 | Windshield Garnish Molding Assembly Procedure: Disconnect the electrical connector, if equipped. |
| 4 | Windshield Garnish Molding Retaining Clip |