DTC 86-1x ("x" can be 0 thru 9 or A thru F): Faulty OPDS Seat-Back Sensor; DTC 86-2x ("x" can be 0 thru 9 or A thru F): Faulty OPDS Seat Support Sensor
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed ( see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures (see PRECAUTIONS AND PROCEDURES ), General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ), and 12 Volt Battery Terminal Disconnection and Reconnection (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software (see SRS UNIT UPDATE ) and retest.
- Clear the DTC memory (see HOW TO CLEAR DTCS ).
- Read the DTC (see HOW TO RETRIEVE DTCS
).
Is DTC 86-1x or 86-2x indicated?
YES -Go to step 3.
NO -Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures (see TROUBLESHOOTING INTERMITTENT FAILURES ). If another DTC is indicated, troubleshoot the DTC.
- Check the connection at the ODS unit harness 18P connector (A) and the sensor connectors (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Are the connections OK?
YES -Go to step 4.
NO -Repair the poor connection, then clear the DTC.
- Replace the OPDS sensor/front passenger's seat-back cover/pad (see FRONT SEAT-BACK COVER REPLACEMENT ).
- Do the ODS unit initialization (see ODS UNIT INITIALIZATION ).
- Clear the DTC memory (see HOW TO CLEAR DTCS ).
- Read the DTC (see HOW TO RETRIEVE DTCS
).
Is DTC 86-1x or 86-2x indicated?
YES -Replace the ODS unit (see ODS UNIT REPLACEMENT ), then clear the DTC. If the DTC is still present, replace the SRS unit (see SRS UNIT REPLACEMENT ).
NO -The system is OK at this time.