DTC 61-2x ("x" can be 0 thru 9 or A thru F): Short in the Driver's Seat Belt Buckle Switch
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed ( see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures (see PRECAUTIONS AND PROCEDURES ) and General Troubleshooting Information (see DTC (DIAGNOSTIC TROUBLE CODES) ).
- Clear the DTC memory (see HOW TO CLEAR DTCS ).
- Turn the ignition switch to LOCK (0), then wait for 10 seconds.
- Turn the ignition switch to ON (II), then buckle and unbuckle the driver's seat belt several times.
- Read the DTC (see HOW TO RETRIEVE DTCS
).
Is DTC 61-2x indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures (see TROUBLESHOOTING INTERMITTENT FAILURES ). If another DTC is indicated, troubleshoot the DTC.
- Turn the ignition switch to LOCK (0).
- Disconnect the floor wire harness 2P connector (A) 'from the driver's seat belt buckle switch.
- Turn the ignition switch to ON (II), then wait for 10 seconds.
- Read the DTC (see HOW TO RETRIEVE DTCS
).
Is DTC 61-2x indicated?
YES -Short to ground in the floor wire harness; replace the floor wire harness, then clear the DTC.
NO -Faulty driver's seat belt buckle switch; replace the driver's seat belt buckle assembly (see FRONT SEAT BELT BUCKLE ), then clear the DTC.