LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 4T45-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Transmission Holding Fixture Assemble >> Special Tools

Special Tools

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

    For equivalent regional tools, refer to Special Tools .

    Fig 1: Installing Transmission Holding Fixture
    GM20158Courtesy of GENERAL MOTORS CORP.
    WARNING: To reduce the possibility of personal injury or transmission damage, make sure, when doing the next step, that all of the bolts for the support fixture are installed as shown, and that the bolts are tightened to 11 N.m (98 lb in).
    NOTE: J 41230:  support fixture should be updated using J 41230-TEM:  drill template due to transmission mounting changes.
  1. Install the J 41230:  support fixture transmission support fixture onto the transmission.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the support fixture bolts. Tighten the support fixture bolts to 11 N.m (8 lb ft).
  3. Install the transmission and the support fixture onto the J 3289-20:  holding fixture base.
  4. Position the transmission with the side cover facing down.
  5. Insert the pin into the J 3289-20:  holding fixture base in order to lock the unit into place.
scientia non olet · About LEMON Manuals