Special Tools

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

J 41103-1: Torque Converter Seal Puller Legs
J 41103-2: Torque Converter Seal Puller Bridge
J 41103-3: Torque Converter Seal Support Body

For equivalent regional tools, refer to Special Tools .

Fig 1: Cross Sectional View Of J 41103 & Components

Courtesy of GENERAL MOTORS CORP.

Insert the three J 41103-1: puller legs under the Torque Converter Seal (54).
Insert the J 41103-3: support body over the stator shaft (43).
Insert the J 41103-2: puller bridge over the J 41103-3: support body. Connect the J 41103-1: puller legs into the slots on the J 41103-2: puller bridge.

NOTE: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.

Tighten the forcing screw on the J 41103-2: puller bridge until the J 41103-1: puller legs remove the torque converter seal (54).