Special Tools

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

J 41229: Manual Shaft to Case Pin Installer or equivalent

For equivalent regional tools, refer to Special Tools .

Fig 1: Installing Manual Shaft Seal

Courtesy of GENERAL MOTORS CORP.

Install a new manual shaft seal (809) into the case (51). Use a 13 mm socket.

Fig 2: Installing Manual Shaft Pin With J 41229

Courtesy of GENERAL MOTORS CORP.

CAUTION: Use J 41229 to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too deep, the case bore may crack.

Install the manual shaft pin (803) into the case. Use the J 41229: pin installer or equivalent.

Fig 3: View Of Parking Lock Actuator Assembly & Manual Shaft And Detent Lever Assembly

Courtesy of GENERAL MOTORS CORP.

With the manual valve to detent lever link (802) and the parking lock actuator assembly (807) attached, install the manual shaft and detent lever assembly (806) into the case.
Ensure that the parking lock actuator rod is correctly positioned into the actuator guide.