Intermediate Fourth Band Assembly Installation

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Intermediate Fourth Band Assembly

Courtesy of GENERAL MOTORS CORP.

Assemble a new Intermediate/Fourth band (100) into the transmission case.

Fig 2: Checking Proper Positioning Of Intermediate/Fourth Band

Courtesy of GENERAL MOTORS CORP.

In order to verify the proper positioning of the band, insert a screwdriver through the Intermediate/Fourth servo bore. The screwdriver should press on the servo pin rest and compress the band around the reverse clutch housing.