Input Speed Sensor Installation
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the input speed sensor (46) to the transmission case.
- Install the input speed sensor bolt (15). Hand start the bolts. Tighten the input speed sensor bolt to 12 N.m (9 lb ft).
- Route the input speed sensor wiring harness in the case channel.
- Connect the input speed sensor connector to the input speed sensor.
- Install the wire harness retainer and wire harness retainer bolt. Tighten the wire harness retainer bolt to 12 N.m (9 lb ft).
NOTE:
The tab on the sensor housing (46) fits into the recess on the case boss.
NOTE:
For drive sprockets with 35 teeth, use a black sensor housing. For drive sprockets with 32 or 33 teeth, use a natural colored sensor housing.
CAUTION:
Refer to Fastener Caution
.