Final Drive Internal Gear Removal

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fretting Ring

Courtesy of GENERAL MOTORS CORP.

NOTE: Note orientation of the internal gear before removal. It must be installed in the same orientation as it was assembled to prevent possible final drive noise.

NOTE: The fretting ring (119) is in the case ring groove. Do not remove the fretting ring unless it appears damaged.

Remove the final drive internal gear (118).