LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 4T45-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Spacer Plate Installation

Control Valve Body Spacer Plate Installation

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Spacer Plate Support & Spacer Plate
    GM1844265Courtesy of GENERAL MOTORS CORP.
    CAUTION: A new spacer plate assembly must be installed to prevent possible transmission damage.
    NOTE: The non-Driver Shift Control (DSC) 4T40-E/4T45-E has a different spacer plate than the 4T45-E Driver Shift Control (DSC). The DSC spacer plate has one notch on it. The NON-DSC spacer plate has two notches on it.
  1. Install a new spacer plate assembly (90) onto the channel plate.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the spacer plate support (21) and the two bolts (20) onto the spacer plate. Hand start the bolts. Tighten the bolts to 14 N.m (10.5 lb ft).
scientia non olet · About LEMON Manuals