Special Tools

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

J 36850: Assembly Lubricant

For equivalent regional tools, refer to Special Tools .

Fig 1: Identifying Accumulator Piston Seals

Courtesy of GENERAL MOTORS CORP.

Assemble the new accumulator piston seals (30) on the three accumulator pistons (29).
Install the 1-2 and 2-3 accumulator assist springs (47, 125).
Install the accumulator pistons (29) into the channel plate over the guide pins. The pistons are identical. You can assemble the pistons in any of the three accumulator bores.
In order to retain the pistons, apply J 36850: lubricant onto the piston seals.
Install the manual valve (800) into channel plate.