LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 4T45-E - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Automatic Transmission Fluid Pan and Gasket Installation

Automatic Transmission Fluid Pan and Gasket Installation

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Pan and Gasket
    GM2388564Courtesy of GENERAL MOTORS CORP.
  1. Inspect the oil pan (88) for cracks, dents or damage to the gasket sealing surface.
  2. Inspect the gasket (87) for cuts or other damage. The bottom pan gasket is reusable if not damaged.
  3. Clean and dry the bottom pan, and gasket. Discard magnet (89), and install two magnets (120).
    4. Fig 2: View Of Bottom Pan & Gasket
    GM20163Courtesy of GENERAL MOTORS CORP.
  4. Install the gasket (87) and bottom pan (88) onto the transmission case.
    5. Fig 3: Locating Bottom Pan Bolts
    GM20837Courtesy of GENERAL MOTORS CORP.
  5. Install the twelve bottom pan bolts (81).
    6. Fig 4: Identifying Twelve Bottom Pan Bolts
    GM20323Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  6. Hand start the bolts. Tighten the bottom pan bolts to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals