LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Mechanical - 2.2L) >> Repair Instructions - On Vehicle >> Powertrain Mount Balancing - Lower

Powertrain Mount Balancing - Lower

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
    NOTE: Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Loosen the front transaxle mount through bolt.
    3. Fig 2: Identifying Rear Transaxle Mount Through Bolt
    GM1647340Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear transaxle mount through bolt.
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    5. CAUTION: Refer to Fastener Caution .
  5. Tighten the rear transaxle mount through bolt to 100 N.m (74 lb ft).
    6. Fig 3: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
  6. Tighten the front transaxle mount through bolt to 100 N.m (74 lb ft).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals