LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Mechanical - 2.2L) >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pan Drain Bolt
    GM758466Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Place a drain pan under the oil pan drain plug.
  3. Remove the oil pan drain plug.
  4. Drain the engine oil.
  5. Remove the engine drive belt. Refer to Drive Belt Replacement .
  6. Remove the lower AC compressor bolt.
    7. Fig 2: Identifying Oil Pan Bolts
    GM1578309Courtesy of GENERAL MOTORS CORP.
  7. Remove the 4 oil pan to transaxle bolts (1).
  8. Remove the oil pan bolts.
    9. Fig 3: Identifying Oil Pan
    GM1578310Courtesy of GENERAL MOTORS CORP.
  9. Remove the oil pan
  10. Remove any old oil pan sealant (1).
scientia non olet · About LEMON Manuals