LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Mechanical - 2.2L) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Balancer
    GM412138Courtesy of GENERAL MOTORS CORP.
  1. Position the crankshaft balancer.
  2. Install a NEW crankshaft balancer bolt.
    3. Fig 2: View Of Harmonic Balancer Holder J38122-A
    GM467429Courtesy of GENERAL MOTORS CORP.
  3. Use the J 38122-A  to hold the crankshaft balancer in order to prevent the balancer from rotating while tightening the bolt.
    4. CAUTION: Refer to Fastener Caution .
  4. Tighten the crankshaft balancer bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft) plus an additional 125 degrees using the J 45059  .

  5. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals