LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Mechanical - 2.2L) >> Repair Instructions - Off Vehicle >> Engine Block Assemble (LAP)

Engine Block Assemble (LAP)

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Passage Plug, Oil Flow Check Valve & Water Jacket Drain Plug
    GM412447Courtesy of GENERAL MOTORS CORP.
  1. Install the drain plug in the water pump.
  2. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) to the plug before installation.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the coolant jacket plugs and tighten to 35 N.m (26 lb ft).
  4. Apply sealer GM P/N 12346004 (Canadian P/N 10953480 to the plugs before installation.
  5. Install the rear oil passage plugs and tighten to 60 N.m (44 lb ft).
  6. Install the other oil passage plugs and tighten to 35 N.m (26 lb ft).
    7. Fig 2: View Of Crankshaft Position Sensor
    GM630345Courtesy of GENERAL MOTORS CORP.
  7. Lubricate the crankshaft position sensor O-ring with engine oil.
  8. Install the crankshaft position sensor and bolt and tighten to 10 N.m (89 lb in).
    9. Fig 3: View Of Engine Oil Pressure Sensor
    GM630350Courtesy of GENERAL MOTORS CORP.
  9. Install the oil pressure switch and tighten to 26 N.m (19 lb in).
    10. Fig 4: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
  10. Install the knock sensor and bolt and tighten to 25 N.m (18 lb ft).
scientia non olet · About LEMON Manuals