LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Exhaust System) >> Repair Instructions >> Front Wheel Drive Shaft Joint Boot Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Drive Shaft Heat Shield
    GM878832Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the wheel drive shaft heat shield bolt at the transaxle mount bracket.
  3. Remove the drive shaft heat shield bolt at the engine block.
  4. Remove the wheel drive shaft heat shield.
scientia non olet · About LEMON Manuals