LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Exhaust System) >> Repair Instructions >> Front Wheel Drive Shaft Joint Boot Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Drive Shaft Heat Shield
    GM878832Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft heat shield into position on the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the wheel drive shaft heat shield bolt to the engine block and tighten the bolt to 30 N.m (22 lb ft).
  3. Install the wheel drive shaft heat shield bolt to the transaxle mount bracket and tighten the bolt to 10 N.m (89 lb in).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals