LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Exhaust System) >> Repair Instructions >> Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (LNF) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exhaust Pipe Insulators
    GM1631769Courtesy of GENERAL MOTORS CORP.
  1. To aid in installation, add a non petroleum based lubricant onto the insulators.
  2. Clean the mating surface on the catalytic converter of any remaining gasket material.
  3. With the aid of an assistant, install the resonator pipe and the muffler to the insulators.
  4. Position the new gasket on to the resonator pipe and install the resonator pipe to the catalytic converter.
    5. Fig 2: Exhaust Hanger Insulators
    GM1631765Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Install the resonator pipe nuts and tighten to 46 N.m (34 lb ft).
  6. Install the rear axle assembly. Refer to Rear Axle Replacement .
  7. Inspect for exhaust leaks and underbody clearance.
scientia non olet · About LEMON Manuals