LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Exhaust System) >> Repair Instructions >> Exhaust Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Heat Shield, Rivets & Nuts
    GM1631773Courtesy of GENERAL MOTORS CORP.
  1. Position the heat shield to the underbody.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the heat shield nut (2).

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  3. Install 4 NEW heat shield rivets (1).
    4. Fig 2: Exhaust Pipe Insulators
    GM1631769Courtesy of GENERAL MOTORS CORP.
  4. To aid in installation, spray a non petroleum based lubricant onto the insulators.
  5. Raise the resonator pipe and the muffler to the insulators and attach.
  6. Install the catalytic converter. Refer to Catalytic Converter Replacement (LNF)  or Catalytic Converter Replacement (LAP) .
scientia non olet · About LEMON Manuals