Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Upper Radiator Mounts

Courtesy of GENERAL MOTORS CORP.

Verify that the upper radiator mounts are installed in the vehicle.

Fig 2: View Of Upper Radiator Air Baffle

Courtesy of GENERAL MOTORS CORP.

Install the upper radiator air baffle.

Fig 3: Aligning Upper Radiator Mount Pins With Upper Radiator Mounts

Courtesy of GENERAL MOTORS CORP.

Raise the radiator and condenser into position. Verify that the upper radiator mount pins align with the upper radiator mounts.

Fig 4: View Of Lower Radiator Mount, Brackets And Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the lower radiator mounts, brackets, and bolts and tighten the bolts to 25 N.m (18 lb ft).

Fig 5: View Of Left Engine Splash Shield-To-Radiator Mount Push-In Retainer

Courtesy of GENERAL MOTORS CORP.

Install the right engine splash shield to radiator mount push-in retainer.
Install the left engine splash shield to radiator mount push-in retainer.

Fig 6: View Of Air Dam And Push-In Retainers

Courtesy of GENERAL MOTORS CORP.

Install the air dam and push-in retainers.

Fig 7: View Of Cooling Fan Assembly-To-Radiator Connectors

Courtesy of GENERAL MOTORS CORP.

Align the cooling fan shroud retaining features to the radiator. Pull down on the cooling fan assembly to snap the fan shroud onto the radiator.
Lower the vehicle.