Conditions for Running the DTC: P2119

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

The ignition is ON.
The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
The TP sensor 1 voltage is greater than 1.7 V
The ECM is not commanding the throttle blade.
DTC P2119 runs continuously when the above conditions are met.

DTCs P0120, P0121, P0122, P0123, P0220, P0222, P0223, or P1682 is not set.
The ignition is ON.
The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
The ECM enabled the minimum throttle learn procedure.
DTC P2176 run continuously when the above conditions are met.