LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Engine Controls And Fuel - 2.2L - DTC P0351 To DTC P2544) >> DTC P0351-P0354 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition.
  2. Disconnect the ECM.
  3. Test the affected IC circuit terminal 3 or C for an open, a high resistance, a short to ground and for a short to voltage.
    • If a fault is found, repair the circuit as needed.
  4. Connect the ECM.
  5. Exchange the affected ignition coil/module with the ignition/coil module of a good cylinder.
  6. Start the engine and observe the scan tool.
    • If the DTC or the misfire transfers with the suspect ignition/coil module, replace as needed.
    • If the DTC or the misfire does not transfer with the suspect ignition/coil module, replace the ECM.
scientia non olet · About LEMON Manuals