Conditions for Running the DTC

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The following conditions must be met prior to ignition OFF.

DTCs P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0128, P0446, P0452, P0453, P0455, P0496, P0502, P0562, P0563, P0601, P0602, P0606, P2610 are not set.
The diagnostic runs once after a cold start drive cycle.
The start-up intake air temperature (IAT) is between 2-32°C (36-90°F).
The start-up engine coolant temperature (ECT) is colder than 42°C (108°F).
The start-up IAT and ECT are within 9°C (16°F).
The barometric pressure (BARO) is more than 68 kPa.
The ambient air temperature is between 2-32°C (36-90°F).
The engine run time minimum is 10 minutes.
The vehicle has traveled more than 8 km (5 mi) this trip.
The shut-down ECT is warmer than 74°C (165°F).
The fuel level is between 12-88 percent.
The ignition is OFF.
A refueling event is not detected.
DTC P0442 runs once per drive cycle when the above conditions are met.
One test occurs at ignition OFF after a drive cycle and may require up to 45 minutes to complete. No more than 2 tests per day are allowed.