LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Engine Controls And Fuel - 2.0L - DTC P0243 To DTC P0690) >> DTC P0341-P0343 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the ignition OFF, inspect the engine wiring harnesses carrying the camshaft position sensor circuits for the following conditions:
    • Close routing of aftermarket electrical equipment
    • Close to solenoids, motors, and relays
    • Correct any wire harness routing or component placement conditions, if it is determined to be a possible source of electrical interference
  2. Ignition ON, engine OFF, observe the Camshaft Position Active Counter parameter. The Camshaft Position Active Counter should be at 0.
  3. Start and run the engine. The Camshaft Position Active Counter should increment to 255.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals