LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transmission - 4T45-E - DTC P0218 To DTC P2764) >> DTC P0711, P0712, or P0713 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the AT harness connector at the transmission.
  2. Install the J 44152  to the 20-way connector at the transmission. See Special Tools .
  3. Test for 3106-3923 ohms between the signal circuit terminal L and the low reference circuit terminal M of the transmission.
    • If not within the specified range, test the circuits for a short to ground or an open/high resistance. If a circuit is shorted or open replace the internal transmission wiring harness assembly, if the circuits test normal, replace the TFT sensor.
  4. Test for infinite resistance between each terminal and the transmission housing/case.
    • If not the specified value, test the circuits for a short to ground or an open/high resistance. If a circuit is shorted replace the internal transmission wiring harness assembly, if the circuits test normal, replace the TFT sensor.