LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Automatic Transmission - 4T45-E - DTC P0218 To DTC P2764) >> DTC P0705 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF, observe the scan tool TR Sw. parameter while moving the gear shift lever from Park, to Reverse and through all the ranges. The parameter should match each gear range that is selected.
  2. Observe the TR Sw. A/B/C/P parameter while moving the gear shift lever from Park, to Reverse and through all the ranges. The TR Sw. A/B/C/P parameter should correspond with the Transmission Range Switch Logic table.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals