LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Engine Controls And Fuel - 2.2L - DTC P0010 To DTC P0366) >> DTC P0325, P0326, P0327, or P0328 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the DMM from the KS signal circuit terminal A to the KS signal circuit terminal B on the sensor side of the KS harness connector.
  2. Set the DMM to the 400 mV AC hertz scale and wait for the DMM to stabilize at 0 Hz.
    3. NOTE: DO NOT tap on plastic engine components.
  3. Tap on the engine block with a non-metallic object near the KS while observing the signal indicated on the DMM.
  4. The DMM should display a fluctuating frequency while tapping on the engine block.
scientia non olet · About LEMON Manuals