LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (Engine Controls And Fuel - 2.0L - DTC P000A To DTC P0238) >> DTC P0191, P0192, or P0193 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Engine idling, observe the Fuel Rail Pressure Sensor parameter with a scan tool. The pressure should be approximately 3.5-5.5 Mpa (508-798 psi).
  2. Command an increase and decrease in fuel pressure with a scan tool. Observe the scan tool Desired Fuel Rail Pressure and the Fuel Rail Pressure Sensor parameters. The Desired Fuel Rail Pressure and the Fuel Rail Pressure Sensor should closely match in all the commanded states.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals