Circuit/System Description
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
The stop lamp switch signal circuit is a direct hardwire input to the engine control module (ECM), the transmission control module (TCM) and the center high mounted stop lamp (CHMSL). The modules monitor the stop lamp switch signal circuit to detect when the brake pedal has been applied. The BCM monitors the brake apply sensor signal circuit to determine when the brake pedal is applied. When the brake pedal is applied, the BCM sends a serial data message to the modules indicating that the brake pedal has been applied.