LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (HVAC System - Manual) >> Repair Instructions >> Air Inlet Valve Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Recirculation Actuator
    GM1552372Courtesy of GENERAL MOTORS CORP.
    NOTE: The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.
  1. Install the recirculation actuator.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the recirculation actuator screw.

    Tighten:  Tighten the screw to 2.2 N.m (19 lb in).

    3. Fig 2: Recirculation Actuator Electrical Connector
    GM1552373Courtesy of GENERAL MOTORS CORP.
  3. Install the recirculation electrical connector.
  4. Install the I/P retainer. Refer to Instrument Panel Tie Bar Replacement .
  5. Install the fuse labeled HVAC CTRL (BATT).
    6. NOTE: Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.
  6. Start the engine and let run for one minute.
scientia non olet · About LEMON Manuals