LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Automatic Transmission - 4T45-E - Symptom Troubleshooting And Diagnosis) >> Transmission Fluid Cooler Flushing and Flow Test (J 45096) >> Code Recording Procedure

Code Recording Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Setting Main Function Switch To CODE Position
    GM1212346Courtesy of GENERAL MOTORS CORP.
  1. Turn the main function switch to the CODE position.
    2. NOTE:
    • If power is interrupted prior to the recording of the seven-character code, the code will be lost and the flow rate test will need to be repeated.
    • The flow test must run for a minimum of 8-10 seconds and be above 0.5 gpm for a code to be generated.
  2. Record TESTED flow rate, temperature, cycle and seven-character flow code information on repair order.
scientia non olet · About LEMON Manuals