Poor Fuel Economy
WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Heavy loads being carried or towed
- Acceleration rate too much or too often
- Inspect the brake system for brake drag.
- Inspect for incorrect operation of the speedometer.
- Verify that the engine coolant temperature (ECT) has not shifted in value. Allow the engine to run and reach operating temperature. Observe the ECT Sensor parameter with a scan tool and compare the reading to that parameter listed on the Engine Control Module Scan Tool Information (LNF) list. If the reading is not in the range specified in the list, test the resistance of the ECT sensor. Refer to Temperature Versus Resistance (IAT 2) or Temperature Versus Resistance (ECT) or Temperature Versus Resistance (IAT 1) for resistance specifications. Replace the ECT sensor if the resistance is not within specification. Refer to Engine Coolant Temperature Sensor Replacement . If the sensor is within the specification, test the ECT sensor circuits for high resistance.
- Inspect the mass air flow (MAF) sensor for obstruction, contamination, and damage. Refer to Mass Airflow Sensor Replacement .
- Inspect the throttle body and clean, if necessary. Refer to Throttle Body Cleaning .