Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Remove the underhood electrical center bracket from the vehicle and reposition the electrical center. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .

Fig 1: Supporting Engine/Transmission With Hydraulic Floor Jack

Courtesy of GENERAL MOTORS CORP.

Support the transmission with a floor jack. Use a piece of wood between the jack and the transmission.

Fig 2: View Of Transmission Mount To Transmission Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the transmission mount-to-transmission bracket bolts.

Fig 3: View Of Transmission Mount-To-Mid-rail Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the transmission mount to mid-rail bolts.

Fig 4: Supporting Engine/Transmission With Hydraulic Floor Jack

Courtesy of GENERAL MOTORS CORP.

Using a floor jack, slowly lower the transmission enough to remove the transmission mount from the vehicle.