LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Manual Transmission - Mu3) >> Repair Instructions - On Vehicle >> Transmission Control Lever Knob Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Use adhesive Loctite™ 270 with Activator 7471 or Activator 7649. DO NOT operate the lever until the adhesive has dried (approximately 30 minutes).
  1. Apply adhesive to the knob.
  2. Seat the shifter knob over the shifter lever. Ensure the spring and foam rings are correctly seated.
  3. Position and fit the emblem over the shifter knob.
  4. Vacuum and clean any debris.
scientia non olet · About LEMON Manuals