LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Manual Transmission - Mu3) >> Diagnostic Information and Procedures >> DTC P0807 or P0808 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector of the CPP sensor.
  2. Measure the resistance between the signal terminal B and the low reference terminal A of the CPP sensor. Sweep the CPP sensor through the entire range. The resistance should vary low to high and high to low without any spikes or dropouts.
    • If the resistance is erratic with spikes or dropouts, replace the CPP sensor.
scientia non olet · About LEMON Manuals